Precautions For Molding Machines

Sep 03, 2026

Leave a message

The molding machine is a common piece of foundry equipment. When using a molding machine, it is essential to observe key operational guidelines to ensure safety during work. Many people lack a full understanding of molding machines, often believing that simply putting them into operation and ensuring they run is sufficient. However, correct and safe usage extends the machine's service life and improves production quality. Key points for safe operation include:
1. Operators must be familiar with the machine's mechanical and electrical components, operating sequences, lubrication systems, and other specified usage requirements.
The sand mold compaction sequence involves four steps: vibration compaction, swinging the press head in, final compaction, and swinging the press head out.
The mold stripping sequence involves: clamping the worktable, raising the stripping pins, removing the flask, and resetting the machine assembly.
2. Before starting the machine, check that the lubrication system is intact and lubricated according to regulations. Verify that all fasteners are secure, control handles are in the neutral (zero) position, air valves operate smoothly, and there are no air leaks in the lines. Finally, open the main air valve to purge accumulated air and condensate from the piping.
3. Operating the machine without a load is strictly prohibited; test runs must be performed under load to verify normal operating conditions and ensure proper lubrication. Actual production may only begin after a successful test run.
4. Closely monitor the machine's operation. Frequently use compressed air to blow sand away from lubrication points and moving parts; prevent sand accumulation on lubricated areas.
5. Operate the control handles and air valves smoothly and steadily.
6. Clean the worktable thoroughly after completing a molding cycle before starting the next one.
7. After use, return handles to the neutral (zero) position, close all valves, and clean both the equipment and the surrounding area. Ensure sliding and rotating parts remain clean and lubricated, and carefully stow away all tools and molds.

Send Inquiry