1. Jolt-squeeze molding machines: These machines apply a squeezing action after the initial jolting compaction, resulting in sand molds that are tightly packed at both the top and bottom. The most common type is the jolt-squeeze machine, which utilizes the impact between the descending worktable and a floating jolt plate to compact the molding sand via micro-jolting, followed by a final squeeze. Micro-jolting employs high-frequency (500–1000 cycles/min) and low-amplitude (5–25 mm) vibrations, contrasting with the low-frequency (60–120 cycles/min) and high-amplitude vibrations of standard jolt-only machines. Molds produced by this type of machine are of high quality, and the machine has relatively low requirements for its foundation.
2. Jolt-compaction molding machines: These machines fall into two categories: jolt-only and micro-jolt machines. The flask and pattern are secured to the machine's worktable; compaction is achieved through the inertia of the sand grains as the worktable drops and impacts the anvil base. However, these machines generate significant noise, and the resulting molds exhibit poor compaction in the upper sections; consequently, they have largely been superseded by jolt-squeeze machines.
3. High-pressure molding machines: The squeezing heads on these machines come in various configurations, such as flat, contoured, and multi-head (multi-squeeze-foot) designs. Among them, the high-pressure multi-head molding machine is the most widely used. In this type, the squeezing head is divided into numerous small, vertically movable blocks-or "heads"-capable of exerting immense pressure via hydraulic cylinders. During the squeezing process, each head applies pressure proportional to the height of the pattern beneath it (i.e., the thickness of the sand layer), ensuring the mold achieves high, uniform compaction and hardness. These machines are equipped with micro-jolt mechanisms, enabling them to handle complex pattern shapes. High-pressure multi-head machines typically feature a four-column structure and are available in single-station or dual-station configurations. To accommodate small-to-medium batch casting production, they are often equipped with rapid pattern-plate changing systems, allowing for pattern changes without halting machine operation. By employing high-pressure, multi-head molding, sand casting can produce castings with thin walls, precise dimensions, and smooth surface finishes.
4. Modern molding machines characterized by low noise, low dust emissions, low energy consumption, and high molding precision have emerged-such as vacuum molding machines, static-pressure molding machines, and gas-impact molding machines. Gas-impact molding machines utilize compressed air...
